Initial unsling setup – "Connection to host lost"

  • Post date

FireFly Media Server › Firefly Media Server Forums › Firefly Media Server › Setup Issues › Initial unsling setup – "Connection to host lost"

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 28/01/2007 at 2:33 PM #1045
    JRudner
    Participant

    Hi,

    I tried to follow the steps found here http://wiki.mt-daapd.org/wiki/Quickstart_NSLU2, but I ran into a problem when I had to telnet into the NSLU2 after running the unsling command.

    When I try to telnet into the NSLU2 (step 13), I enter my username and password, I get a quick message that it is running on flash memory, then I get connection to host lost.

    I tried to reset the NSLU2 by holding the reset button, but it doesn’t reset to factory settings.

    Can anybody help. I’m a newbie at this.

    Thanks,

    JRudner

    29/01/2007 at 3:53 AM #8794
    rpedde
    Participant

    @JRudner wrote:

    Can anybody help. I’m a newbie at this.

    http://wiki.fireflymediaserver.org/NSLU2_Installation is the most recent info on installing on NSLU2. Take a look at that, and see if you have departed from one of the steps there. In particular, make sure you read the instructions in the README that came with the unslung firmware — that’s the real instructions for the unslinging part.

    — Ron

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • The forum ‘Setup Issues’ is closed to new topics and replies.