Firefly on Linkstation Post date FireFly Media Server › Firefly Media Server Forums › Firefly Media Server › General Discussion › Firefly on Linkstation This topic has 4 replies, 3 voices, and was last updated 17 years, 10 months ago by vamprecords. Viewing 5 posts - 1 through 5 (of 5 total) Author Posts 05/01/2007 at 2:04 PM #961 vamprecordsParticipant Hi, I got firefly running on a linkstation, and it runs ok, but after 2 hours the link with the music library is gone (on the soundbridge) afer a reset everything is running again, but after 2 hours it’s gone again.. can anybody help me with this problem? The setup is: Linkstation HS-D400GL (using openlink firmware) router: linksys wrt54g Thanks! Martijn 05/01/2007 at 5:18 PM #8250 fizzeParticipant this is a known problem with the router/firewall ๐ did you run stock firmware on the WRT54? See thread(s): http://forums.fireflymediaserver.org/viewtopic.php?t=5363&highlight=hours 05/01/2007 at 6:44 PM #8251 vamprecordsParticipant @fizze wrote: this is a known problem with the router/firewall ๐ did you run stock firmware on the WRT54? See thread(s): http://forums.fireflymediaserver.org/viewtopic.php?t=5363&highlight=hours Yes stock firmware… 06/01/2007 at 2:09 AM #8252 rpeddeParticipant @vamprecords wrote: @fizze wrote: this is a known problem with the router/firewall ๐ did you run stock firmware on the WRT54? See thread(s): http://forums.fireflymediaserver.org/viewtopic.php?t=5363&highlight=hours Yes stock firmware… That might be a multicast problem Try manually setting the interface to promiscuous mode — something like “ifconfig eth0 promisc”. I believe that will do it. 06/01/2007 at 3:25 PM #8253 vamprecordsParticipant @rpedde wrote: @vamprecords wrote: @fizze wrote: this is a known problem with the router/firewall ๐ did you run stock firmware on the WRT54? See thread(s): http://forums.fireflymediaserver.org/viewtopic.php?t=5363&highlight=hours Yes stock firmware… That might be a multicast problem Try manually setting the interface to promiscuous mode — something like “ifconfig eth0 promisc”. I believe that will do it. Ok i’ll try! Thanks, Martijn Author Posts Viewing 5 posts - 1 through 5 (of 5 total) The forum ‘General Discussion’ is closed to new topics and replies. → Welcome